AgTec 3-Rail White PVC Horse and Ranch Fence Kit - 200ft, 25 Panel pack, 54in above ground

This product will ship via Motor Freight.

Inventory may sell out before arrival—pre-ordering is recommended.

Kit Contents:

• 75 x 8 foot rails, 5.5 inch wide, 1.5 Inch thick
• 24 Line Posts -  82 inch long x 5 inch thick posts. Approximately 54 inches go above ground, 28 inches in-ground.
• 2 End Posts - 82 inch long x 5 inch thick posts. Approximately 54 inches go above ground, 28 inches in-ground.
• Spacing between rails is 11.83". Post wall thickness 0.15", rail wall thickness 0.079"
• Posts include 5in flat cap as standard
• Shipment measures approximately 94" x 40" x 43" tall and weights 830lb
• Use our "custom build" product page for custom quantities

Features:

• 5 X Stronger than wood

• Maintenance Free  - No Painting or Sanding

• Won't rot or mildew like wood

• UV Stabilized for decades use outdoor use

• An attractive and strong barrier for horse paddocks and any farm or garden area

• Manufactured to withstand extreme hot or cold climates

• Will not fade or show any signs of deterioration

• Free shipping

• 10 Year Warranty

Premium grade 3-Rail PVC Horse Fence. Are 5 X stronger than wooden fence kits with no painting and staining required. They don't rot or mildew like wooden fence kits and are UV stabilized to last decades outside. Premium grade PVC will last for many decades without fading or showing any signs of deterioration.

Posts are installed approximately 28-36 inches below ground and then typically installed in concrete. Rails easily clip into posts and are notched to stay in place.

Installation Instructions:

Step 1: If using a gate, it is best to assemble your gate first as the gate width and location will determine the layout of the rest of your posts.

Step 2: Install line stakes and run a string line. The string line should be positioned on the side of the posts and be very tight. Use a tape measure and mark the location for each post. Posts should be installed 8 foot apart on center to accommodate the 8ft rails. Note that rails can be cut shorter if necessary.

Step 3: Remove the string line, leaving the stakes, and dig the post holes. If installing with concrete, 5" posts will need a 12" diameter hole (If installing with Fast2K dig an 8” diameter hole), we recommend using Quik-Tubes to contain the concrete. The recommended depth of the holes is 28" - 36" depending on how tall you want the fence.

Step 4: Re-attach the string line to the stakes and place a post in each hole. Use the string line to ensure the fence line is straight as you set the posts.

Step 5: Finally, mix the concrete and fill the hole or quik-tube around the post with concrete to 3" below ground level, ensuring that the post is level and plumb. It is best to use two 80 lb. bags of Quickcrete for each 5" post. We recommend setting posts in concrete one post at a time so corrections are easier to make.